How do I start my Craftsman lawn mower?
Hold onto the recoil starter handle located on the right hand side of the mower and slowly pull the rope Allow the rope to rewind gently Pull the recoil rope rapidly using a complete, full-arm motion before letting the rope return gently Repeat pulling the rope rapidly and returning until the lawn mower starts
What is the choke on a Craftsman riding lawn mower?
The actual choke is located in the opening of the carburetor It is a plate that restricts the air flow into the carburetor when the throttle lever is placed in the choke/start position
Why does my Craftsman mower won’t start?
The carburetor might be clogged A clogged carburetor is most commonly caused by leaving fuel in the lawn mower for a long period of time This sticky fuel can clog up the carburetor and prevent the engine from starting If the carburetor is clogged, try cleaning it with carburetor cleaner
How do you start a choke on a riding lawn mower?
How to Start a Riding Lawn Mower? Sit firmly on the seat Start the Engine Press the Brakes Engage the Parking Brake Put the Gear to Neutral Pull the Throttle onto Choke Position Insert the Ignition Key Turn the Key to the Right hand side/Clockwise
How does a ride on mower work?
How Does a Riding Lawn Mower Work? A riding lawn mower is a gas-powered machine for cutting grass The engine turns a rotating blade that cuts the top off the grass blades to a specified height The operator sits atop the mower on a tractor-type seat with speed and height controls nearby
How do you mow a lawn with a riding mower?
Start on a flat area and keep the blade or blade deck up until the mower is on the grass Before you mow, set your mower to the recommended height for your type of grass Cut only 1/3 of the grass blades at one time Don’t mow while the grass is wet from rain or dew Change your mowing pattern each time you mow
What is the choke position on a lawn mower?
Choke plate – a control on the carburetor which partially closes off the air intake and forces additional suction to increase the amount of fuel drawn into the cylinder Normally, the choke is closed when starting cold and gradually opened in the few seconds after the engine starts
How do you turn on the choke on a Craftsman riding lawn mower?
How to Adjust the Choke on a Craftsman Lawn Mower Pull the choke adjustment knob on the dashboard out completely if the engine is cold Start the engine Push the choke knob in partially until the engine is running smoothly Continue to push the choke adjustment knob in slowly as the engine is warming up
What will cause a riding lawn mower not to start?
There are many reasons a riding lawn mower won’t start—everything from stale gas to ignition switch problems If you constantly have to charge the battery, a bad battery or failed alternator could be causing the problem Lawn mower ignition switch problems can prevent the starter from getting current
Why is my mower not starting?
Your Mower Won’t Start: Other possible causes include: Loose, Dirty or Disconnected Spark Plug in Your Lawn Mower: Check it out, clean off debris, re-connect and tighten Dirty Air Filter: Clean or replace Fuel Not Reaching the Engine: Tap the side of the carburetor to help the flow of gas
Where is the spark plug on a lawnmower?
Spark plugs are typically located on the back or side of a lawn mower engine Look for a short wire that’s about 1/4-in -thick leading to the top of a short, cylindrical protrusion from the engine If you’re not sure where the spark plug is, consult your owner’s manual
What do you do with your lawn mower after winter?
Store the gas in an approved container and take it to the local waste facility to dispose of it as hazardous waste Pour new gas in the tank and reprime the engine If the mower has a two-cycle engine, be sure to mix the gas with the proper amount of two-cycle oil
How does a riding lawn mower deck work?
The blades turn at a high rate of speed, cutting the tops off the grass as they rotate The deck of the riding lawnmower prevents sticks and other debris from flying out from beneath the mower, potentially causing injury or property damage It also channels the grass clippings out the side
What is blade control on a lawn mower?
This feature is referred to as a blade override system A blade override system is a convenient feature for two reasons: It lets you transport the unit from point A to point B effortlessly but without cutting grass along the way
Is it better to mow or edge first?
Trim and Edge First Before you get behind the mower, trim and edge your yard to lessen the risk of damaging trees, plants, and hardscaping by getting too close with your mower
Which direction do you cut grass?
However, if you’re mowing longer grass, I strongly recommend mowing in a counterclockwise direction The clippings discharged from long grass can be substantial, and mowing back over them can interfere with the blades and make it difficult for the mower to do its job correctly
How do you mow a lawn for beginners?
How to Mow the Lawn – Lawn Mowing Tips & Tricks Step 1 – Set Your Mower High Step 2 – Mow Your Lawn When It’s Dry Set Your Mower High Mow a Dry Lawn Vary Your Mowing Pattern Don’t Mow on a Schedule Wait Before Mowing a New Lawn Leave Grass Clippings on Your Lawn Keep Your Mower Blade Sharp