How do I start my Cub Cadet riding mower for the first time?
Why won’t my Cub Cadet engage?
Common solutions for: Cub Cadet Lawn mower blades won’t engage If the PTO clutch is not getting power, if the clutch solenoid is defective, or if the clutch is worn out, the lawn mower blades will not engage The PTO clutch is not repairable—if the clutch is defective, you must replace it
What is the choke position on a riding lawn mower?
Pull the Throttle onto Choke Position You’ll normally find it on the left side of your riding lawn mower They’re easy to identify, thanks to their labeling picture of a rabbit and turtle Move its lever in order to engage the choke Also, you can set the lever between the slow and fast settings
Where is the PTO switch on Cub Cadet?
Find the small bell housing on the underside of the Cub Cadet’s Briggs & Stratton engine This housing is for the PTO clutch
How do you engage PTO on a Cub Cadet mower?
To engage the blades, be sure that your throttle or choke is in the rabbit position Then, push the PTO or blade engage lever forward into the on position
Why is my mower PTO not engaging?
If the PTO clutch is not getting power, if the clutch solenoid is defective, or if the clutch is worn out, the lawn mower blades will not engage The PTO clutch is not repairable—if the clutch is defective, you must replace it The PTO switch provides power to the PTO clutch If the PTO switch is defective, replace it
Should choke be open or closed when starting lawn mower?
Normally, the choke is closed when starting cold and gradually opened in the few seconds after the engine starts It is left fully open once the engine is running and may not need to be closed when starting warm A typical starting procedure for an engine with a choke might be: Close the choke (usually on carburetor)
How do you put a choke on a lawnmower?
Choke – Choke set to full to start a cold engine, after the engine warms up move the choke to the fast setting Some mowers use a snowflake symbol for the choke
How do I start my lawn mower with a bad starter?
Attach a jumper cable from the large lug where the engine starter cable and other lugs connect to the battery cable Finally, rotate the ignition keys of the lawn mower If it just clicks without starting the lawn mower, you may need to replace the solenoid
What is Cub Cadet PTO?
The PTO (or power take-off) belt is part of a pulley system that operates the blades on your riding lawn mower It runs off the electric clutch system in your engine If you hear squealing during operation or see dry rot on your PTO belt, you may need to replace it
How does a PTO engage?
The PTO is engaged and disengaged using the main transmission clutch and a remote control mechanism which operates on the PTO itself Typically, an air valve is used to engage the PTO, but a mechanical linkage, electric or hydraulic mechanism are also options
What does PTO blade mean?
The power take off (PTO) clutch in your lawnmower is the drive pulley that transfers the power of the engine to the blade It consists of a few basic parts
Why wont my blades won’t engage?
Belt-the number one cause for your blades not to engage is that your belt is either stretched or loose causing it to slip or fall off completely Belt could have snapped also When you are trying to process too much grass/leaves they could pack up under your deck and push off your belt
How do I know if my PTO clutch is bad?
Activate the PTO engagement lever, then disengage it Turn it on and off several times If you do not hear a disengagement noise or see the power takeoff pulley stopping or slowing down at any time, it indicates the clutch and plates have galled together from excessive heat, or the slip ring has jammed
Why does my Cub Cadet keep shutting off?
The carburetor might be clogged A clogged carburetor is most commonly caused by leaving fuel in the lawn mower for a long period of time This sticky fuel can clog up the carburetor and cause the engine to stall If the carburetor is clogged, try cleaning it with carburetor cleaner
What is a PTO clutch on a riding mower?
An electric lawnmower clutch, commonly called a power takeoff clutch (PTO), is the part of a lawnmower or riding tractor responsible for engaging the blade The electric clutch helps to transfer engine power to the drive train The clutch connects two drive shafts and is controlled by a toggle switch
Where is the choke?
The choke is located before the throttle, and manages the total amount of air going into the engine The choke is only used when starting a cold engine When doing a cold start, the choke should be closed to limit the amount of air going in
What is PTO on a lawn mower?
The PTO is a switch or lever found on tractors and mowers and stands for Power Take Off This can be an electric switch or mechanical engagement that takes engine power to operate the mower deck or an implement The PTO can run mowers by either a belt or a shaft
How do you use a choke on a tractor?
The choke will bring more fuel in quickly When cold, once it fires, take the choke off SLOWLY If it starts to kill, quickly put it back on For cold starts, when the machine has been idle for a while, I’ll set the throttle about 1/2 and turn it over a few revolutions BEFORE choking
How do you know if its a choke?
When the “choke” is closed you will see a metal plate restrict the opening of the carb throat This is the CHOKE ON! position When the “choke” is open you will not see the metal plate and you can see right into the throat of the carb