How do you cross a slope on an off road motorcycle?
Traversing a Slope Keep both feet on the footrests, and lean to the uphill side Keep your speed steady Sudden acceleration could tip the ORV If the surface of the hill is loose, turn the ORV to a slightly steeper angle uphill If an ATV begins to tip, decrease your uphill angle or even ride downhill a while
What technique should you use when making a slow turn on a motorcycle offroad Ed?
For slow turns, slide forward and to the outside—then lean into the turn For fast turns, slide forward and to the inside—then lean into the turn
What should you do if you are riding alone on your ATV and must cross a paved road?
If you must cross a road, consider the legal operation of an ATV and follow this safe procedure: Pick a crossing point where you have good visibility in both directions Bring your vehicle to a complete stop on the shoulder of the road Look both ways, and yield to oncoming traffic
What do you do if your ATV starts tipping?
If your ATV starts to tip, turn downhill If you can’t turn because of obstructions, jump off on the uphill side Keep your speed steady Sudden acceleration could tip your ATV
Why should you practice quick turns on an ATV?
Quick turns will help you avoid obstacles To do this, you will adjust your body position, shift your weight, and change your speed
What is a K turn on an ATV?
The three-point turn (sometimes called a Y-turn, K-turn, or broken U-turn) is the standard method of turning a vehicle around to face the opposite direction in a limited space, using forward and reverse gears This is typically done when the road is too narrow for a U-turn
When should you move the choke to the ON position on a motorcycle?
Starting Your OHM Check the following conditions before starting The fuel is on The ignition is on The motorcycle is in neutral The key or switch is in the “Start” or “On” position If the engine is cold, use the choke until it runs smoothly Then move the choke to the “Off” position
What should you avoid when riding downhill on an ATV?
Stay focused and be prepared to stop—losing control is the greatest hazard Do not release the clutch Keep the clutch engaged to help you slow down Pump the brake (alternately squeezing and releasing the brake) every few seconds to maintain a slow speed or stop
When driving your ATV at night what should you always be able to do?
Never “overdrive your headlight” You always should be able to stop within the length of the headlight beam If the headlight suddenly reveals an obstacle, you should be able to stop before you hit it An ATV high beam is effective for about 200 feet
What does it mean when the ATV rider in front of you pats his or her helmet with an open palm?
Cops Ahead – When you see a fellow rider coming at you in the opposite direction and they are tapping the top of their helmet with their open palm face down, they are letting you know that law enforcement is ahead
What makes an ATV different from a car or motorcycle?
ATVs handle differently from other vehicles such as motorcycles and cars Never ride on paved roads except to cross when done safely and permitted by law – another vehicle could hit you ATVs are designed to be operated off-highway Never ride under the influence of alcohol or drugs
What is the correct way to stop an ATV while you are descending?
Stopping While Descending As you descend, shift your weight back toward the rear of the ATV On steep slopes, straighten your knees and elbows but don’t lock them Bend forward so that your rear is over the back of the seat Shift into low gear, and apply the brakes to slow your descent
What does check first remind an ATV operator do?
An easy way to remember the items to inspect before each ride is “CHEC FIRST” Check for damage and tightness Add lubrication as needed
Why is driving an ATV on paved surfaces a cause of accidents?
Riding on Paved Surfaces ATVs are specifically designed for off-road use For this reason, they perform poorly on flat, paved surfaces and may cause fatal accidents
What is the best place to stop along the trail?
Be safe and considerate when you stop along the trail Never stop side-by-side, in the middle of the trail, at the crest of a hill, or around a corner on the trail Also never block an intersection Remember to shut off your engine
How do I learn to ride off the road?
11 Tips For Riding Off-Road Come prepared Adjust Your Clutch Lever For Two-Finger Operation In Sand/Silt/Deep Stuff, Speed Up And Lean Back To Turn, Push The Bike Down Stay Off The Front Brake In Turns Look Where You Want To Go, Not Where You Don’t Stand Up In the Footpegs Shift Weight On The Outside Peg
What is the posting position on an ATV?
Posting is a position that essentially uses the mechanics of your body as a shock absorber on bumpy or rough trails Think of riding your bike over bumpy terrain – you wouldn’t sit because it would be uncomfortable
Why should you wash your ORV after every ride?
To prevent the spread of weeds, wash your ORV after every ride
What riding position is the best position for stability?
Sitting provides the lowest center of gravity for maximum stability and safety This is the only position recommended for carrying passengers if the vehicle is designed for that purpose Keep your feet firmly on the footrests
What is AK turn in driving?
The three-point turn is a way of turning a vehicle around in a small space by going forward, turning to one side, then backing up, turning in order to face the other direction, then going forward again The three-point turn is sometimes called a Y-turn, K-turn, or broken U-turn
How far will an ATV going 1 mph travel in 1 second?
An AV will travel 15 feet in 1 second when going 1 mph
Is choke on closed or open?
The choke is only used when starting a cold engine When doing a cold start, the choke should be closed to limit the amount of air going in Once the car has warmed up, if the choke does not open fully, the restriction in air may result in reduced power