Turn the ignition key to the “Start/On” position and crank the engine for up to five seconds to engage it Release the key to the “Run” position once the engines starts If the engine fails to start, let the key fall back to the “Run” position and wait for 10 seconds before repeating the starting procedure
How come my riding lawn mower won’t start?
There are many reasons a riding lawn mower won’t start—everything from stale gas to ignition switch problems If you constantly have to charge the battery, a bad battery or failed alternator could be causing the problem Lawn mower ignition switch problems can prevent the starter from getting current
Do they still make Scotts riding lawn mowers?
Today, an array of lawn mowers are sold under the Scotts name, including reel-style, human powered mowers, electric and gas walk behind mowers (of both the push and self-propelled variety), standard riding mowers, and zero turn mowers We cover many of these in our Scotts lawn mower reviews
How do you start a riding lawn mower after winter?
Turn the choke off after a few attempts and try again Give the spark plug wire a little tug to see if it’s loose If it is, push it onto the plug and try starting the mower If there isn’t any difference, remove the plug with a spark plug wrench and clean the gap with an emory board
Where is the choke on a riding mower?
Pull the Throttle onto Choke Position You’ll normally find it on the left side of your riding lawn mower They’re easy to identify, thanks to their labeling picture of a rabbit and turtle Move its lever in order to engage the choke
Where is the choke on John Deere riding mower?
Move the throttle located to the left of the steering wheel into the choke position if the engine is cold Move it into the half-speed position if the engine is warm Some models of riding mowers have a choke knob instead of a choke position on the throttle
Why does my mower click when I try to start it?
The clicking noise comes from a part called the starter solenoid The solenoid connects the battery to the starter motor when the solenoid is energized The most likely causes of the solenoid clicking instead of energizing full are: Low battery voltage – Battery needs charging or replacement
What are the symptoms of a bad solenoid on a riding lawn mower?
Look for the large terminal posts on the solenoid where the thick red wires connect to the solenoid Touch the metal shaft of a screwdriver to both of the large terminals at the same time If the engine turns over and starts, the solenoid is bad and should be replaced
Who sold Scotts lawn mowers?
Related brands: John Deere The Scotts/Miracle Gro company sold a line of Scotts branded tractors, all built by other maufacturers The final line of Scotts lawn tractors were built by John Deere These same models were later sold as Sabre brand tractors by Deere
What year did John Deere make Scotts mowers?
The Scotts S1742 model riding lawnmower was manufactured by The John Deere Co from 1998 to 2001 In the model designation “S1742,” “S” stands for Scotts, “17” represents the 17-horsepower engine and the number “42” refers to the 42-inch, mid-mount cutting deck
Why won’t my lawnmower start after the winter?
Here are three common reasons your lawn mower won’t start after a long winter: 1 There is buildup clogging your carburetor and/or there is stale fuel in the float bowl You’ll also need to drain fuel tank and replace with fresh fuel and fuel stabilizer
What happens if you leave gas in lawn mower over winter?
Unused gas left in a mower over the winter can get stale, gumming up the carburetor and inviting rust Turn the mower off and allow the engine to cool, then siphon excess gas into a clean can (You can put this gas in your car, provided it hasn’t been mixed with oil)
How do I start my lawn mower with a bad starter?
Attach a jumper cable from the large lug where the engine starter cable and other lugs connect to the battery cable Finally, rotate the ignition keys of the lawn mower If it just clicks without starting the lawn mower, you may need to replace the solenoid
What is the choke on a John Deere?
The choke on a John Deere lawn tractor aids the engine in a cold start When the throttle cable becomes out of adjustment, the choke may not be working
When I turn the key it just clicks once?
Clicking when you turn the key is usually a sign that there is not enough power for the starter to fully turn If your battery is new, then that is likely not the source of the problem It may be possible that one of the components, perhaps a relay, switch, or even the starter, have failed
Where is the solenoid located?
The location of a solenoid can vary depending on your vehicle’s make and model Most cars have their solenoids mounted right on the starter motors, connected to other “starter” components like the starter gear and starter control terminal
How do you jump a starter solenoid on a lawn mower?
How to jump a solenoid on a lawnmower, step by step Step 1: Turn the ignition switch on Step 2: Locate the lawnmower solenoid Step 3: Find the relevant terminals Step 4: Clean the carbon and rust deposits from the terminal Step 5: Jump the solenoid
What are the symptoms of a bad starter solenoid?
As a result, the common signs of a bad starter solenoid include: Engine Doesn’t Crank or Start No Clicking Noise When Trying to Start the Engine Starter Spins Without Fully Engaging the Flywheel (Rare) Engine Cranks Slowly (Rare) Test the battery Check That Power is Getting to the Starter Solenoid
Where are great states reel mowers made?
The company purchased Shelbyville reel lawn mower manufacturer, Great States Corp, in 1936 Today, the mowers are manufactured in the same building in Shelbyville with a corporate office in Muncie
How can you tell the year of a riding lawn mower?
Write down the first six numbers of the mower’s serial number The first two numbers are the mower’s month of manufacture The second two numbers indicate the day of manufacture and the third two will signify the year of manufacture
How do you read a John Deere 13 digit serial number?
Identify the last six letters and numbers in a 13-symbol VIN or the last five digits in a 17-symbol VIN This is the serial number and is unique to your specific tractor The serial number can be used to track and identify individual John Deere tractors